D1102 Torklift SuperHitch Receiver 2003-2012 Dodge/RAM Pickups
D1102 Torklift SuperHitch Receiver 2003-2012 Dodge/RAM Pickups
- Heading
- Heading
- Heading
Couldn't load pickup availability
Proudly Made in USA with Factory Lifetime Warranty
Fits 2003-2012 Dodge/RAM 2500 & 3500 short and long bed pickups with factory installed hitch. (See details below)
SuperHitch frame mounted receiver rated up to 20,000 lbs. trailer weight and 2,000 lbs. hitch weight when using weight distribution, in either the upper or lower receivers.*
Uses industry standard 2" square ball mounts.
Holes pre drilled for Torklift truck camper tie down installation.
Trailer weight capacity is 17,000 lbs. without weight distributing hitch.
Hardened hitch pin hole reinforcement plates included to prevent premature wear.
Extension towing capacity up to 12,000 lbs. with 48" SuperTruss receiver extension **
SuperTruss Extensions are available in 8 different lengths from 21" to 60" (SOLD SEPARATELY) ***
Designed for up to 12' campers.
Both the SuperHitch frame mount receiver and the SuperTruss receiver extensions use Industry standard 2" x 2" ball mounts. Eliminates the need for two ball mounts.
Please view the images to determine if your truck has the FACTORY or DEALER installed hitch.
Notice that the DEALER installed hitch has the center, receiver box portion, bolted to the cross tube. There will be one (1) vertical bolt on each side of the receiver tube located between the hitch cross tube and the truck bumper.
Notice that the DEALER installed hitch has the center, receiver box portion, bolted to the cross tube. There will be one (1) vertical bolt on each side of the receiver tube located between the hitch cross tube and the truck bumper.
If your truck has the dealer installed hitch you will need to order Torklift part number D1101. You will be required to remove the bolted on center section to allow installation of the Torklift SuperHitch.
The FACTORY installed hitch has the center section welded to the cross tube.
If your truck has the welded center section you will need Torklift part number D1102, which does NOT require the removal of any part of your existing hitch.
Please look carefully at your truck, the images and instructions on this page, to be certain you are ordering the correct Torklift SuperHitch for your Dodge pickup.
Incorrect orders for either of these two part numbers will incur restocking fees.
* When used without SuperTruss extension
** When using weight distribution hitch.
*** SuperTruss Extensions Sold Separately
NOT Included With SuperHitch Receiver
