This electric motor retrofit kit fits any single speed heavy duty 12,000 lb. sidewind trailer jack with a 1" shaft diameter.
Maximum lifting capacity at jack leg(s) appx. 3000 lbs.
Actual lifting capability can vary depending on jack condition, trailer geometry, parking position etc.
This kit was designed by the factory to work on basic 2-3 horse trailers with NO living quarters.
No two trailers are the same and manufacturer's Data Plates are notoriously inaccurate.
The best method to determine if this kit will lift your trailer is to check the weight on the jack legs with a scale at a truck stop, rock quarry, feed store, DOT weigh station, etc.
Designed to be mounted to face of trailers such as gooseneck horse or stock trailers and fifth wheel or gooseneck race car or cargo trailers.
Requires approximately 10" clear space beside jack for mounting.
Comes complete with weather resistant switch and switch box, jack shaft coupler, pins, emergency crank handle and installation instructions.
Cranking Speed at No Load is appx. 16 Revolutions Per Minute.
Jack shown for illustration purpose ONLY. Sold separately.
Wiring and fuse or circuit breaker not included.
*See "Terms and Policies".